#
# MPTCP configuration
#
config MPTCP
bool "MPTCP protocol"
depends on (IPV6=y || IPV6=n)
default y
---help---
This replaces the normal TCP stack with a Multipath TCP stack,
able to use several paths at once.
menuconfig MPTCP_PM_ADVANCED
bool "MPTCP: advanced path-manager control"
depends on MPTCP=y
default y
---help---
Support for selection of different path-managers. You should choose 'Y' here,
because otherwise you will not actively create new MPTCP-subflows.
if MPTCP_PM_ADVANCED
config MPTCP_FULLMESH
tristate "MPTCP Full-Mesh Path-Manager"
depends on MPTCP=y
default y
---help---
This path-management module will create a full-mesh among all IP-addresses.
config MPTCP_NDIFFPORTS
tristate "MPTCP ndiff-ports"
depends on MPTCP=y
default n
---help---
This path-management module will create multiple subflows between the same
pair of IP-addresses, modifying the source-port. You can set the number
of subflows via the mptcp_ndiffports-sysctl.
config MPTCP_BINDER
tristate "MPTCP Binder"
depends on (MPTCP=y)
default n
---help---
This path-management module works like ndiffports, and adds the sysctl
option to set the gateway (and/or path to) per each additional subflow
via Loose Source Routing (IPv4 only).
choice
prompt "Default MPTCP Path-Manager"
default DEFAULT
# default Full-mesh
help
Select the Path-Manager of your choice
config DEFAULT_FULLMESH
bool "Full-mesh" if MPTCP_FULLMESH=y
config DEFAULT_NDIFFPORTS
bool "ndiff-ports" if MPTCP_NDIFFPORTS=y
config DEFAULT_BINDER
bool "binder" if MPTCP_BINDER=y
config DEFAULT_DUMMY
bool "Default"
endchoice
endif
config DEFAULT_MPTCP_PM
string
default "default" if DEFAULT_DUMMY
default "fullmesh" if DEFAULT_FULLMESH
default "ndiffports" if DEFAULT_NDIFFPORTS
default "binder" if DEFAULT_BINDER
default "default"
default y
menuconfig MPTCP_SCHED_ADVANCED
bool "MPTCP: advanced scheduler control"
depends on MPTCP=y
default y
---help---
Support for selection of different schedulers. You should choose 'Y' here,
if you want to choose a different scheduler than the default one.
if MPTCP_SCHED_ADVANCED
config MPTCP_ROUNDROBIN
tristate "MPTCP Round-Robin"
depends on (MPTCP=y)
default y
---help---
This is a very simple round-robin scheduler. Probably has bad performance
but might be interesting for researchers.
choice
prompt "Default MPTCP Scheduler"
default DEFAULT
# default Round-Robin
help
Select the Scheduler of your choice
config DEFAULT_ROUNDROBIN
bool "Round-Robin" if MPTCP_ROUNDROBIN=y
---help---
This is the round-rob scheduler, sending in a round-robin
fashion..
config DEFAULT_SCHEDULER
bool "Default"
---help---
This is the default scheduler, sending first on the subflow
with the lowest RTT.
endchoice
endif
config DEFAULT_MPTCP_SCHED
string
depends on (MPTCP=y)
default "default" if DEFAULT_SCHEDULER
default "roundrobin" if DEFAULT_ROUNDROBIN
default "default"