psplash

git://git.yoctoproject.org/psplash

Try these steps:

1. Set the cross compile environment properly, based on the toolchain you are using. This means setting variables CC, LD, AS, OBJCOPY, etc.

2. Run this command:

# autogen.sh

3. Assuming that you'd like to: keep psplash in "/usr/bin" of target filesystem, run the following command.

# ./configure --shared --prefix=/usr

You may want to confirm the location of psplash in current filesystem that you are planning to customize.

4) Build it.

# make

5) Install it to a local path.

# make install DESTDIR=./_install

6) Move the contents of _install directory to the target filesystem.

Since you are modifying the contents of an existing filesystem - rather than creating new one, i would recommend using the same toolchain that was used to create the original filesystem.