MMDVM中继板测试软件MMDVMCal

运行方法:

只支持windows 64位系统

32位下载:https://share.weiyun.com/52uHAO5

64位下载:https://share.weiyun.com/5IgdqvL

mmdvmcal.exe \.com18

com18是端口号,每台电脑都不同,比如在设备管理器看到是串口8改为8即可

按b是测试DMR的误码率,默认接收频率433mhz

This is the calibration program to be used with the MMDVM and MMDVM_HS. It is started by
adding the serial port onto the command line. On Windows the serial port must be
prefixed with . as in .COM4 to be valid. Once started the program takes
the following commands:

  • MMDVM:
CommandDescription
H/h Display help
Q/q Quit
W/w Enable/disable modem debug messages
I Toggle transmit inversion
i Toggle receive inversion
O Increase TX DC offset level
o Decrease TX DC offset level
C Increase RX DC offset level
c Decrease RX DC offset level
P/p Toggle PTT inversion
R Increase receive level
r Decrease receive level
T Increase transmit level
t Decrease transmit level
d D-Star mode
D Set DMR Deviation Mode. Generates a 1.2Khz Sinewave. Set radio for 2.75 Khz Deviation
L/l DMR Low Frequency Mode (80 Hz square wave)
A DMR Duplex 1031 Hz Test Pattern (TS2 CC1 ID1 TG9)
M/m DMR Simplex 1031 Hz Test Pattern (CC1 ID1 TG9)
a P25 1011 Hz Test Pattern (NAC293 ID1 TG1)
N NXDN 1031 Hz Test Pattern (RAN1 ID1 TG1)
K/k BER Test Mode (FEC) for D-Star
b BER Test Mode (FEC) for DMR Simplex (CC1)
B BER Test Mode (1031 Hz Test Pattern) for DMR Simplex (CC1 ID1 TG9)
J BER Test Mode (FEC) for YSF
j BER Test Mode (FEC) for P25
n BER Test Mode (FEC) for NXDN
g POCSAG 600Hz Test Pattern
S/s RSSI Mode
V/v Display version of MMDVMCal
<space> Toggle transmit
  • MMDVM_HS:
CommandDescription
H/h Display help
Q/q Quit
W/w Enable/disable modem debug messages
E/e Enter frequency
F Increase frequency
f Decrease frequency
Z/z Enter frequency step
T Increase deviation
t Decrease deviation
P Increase RF power
p Decrease RF power
C/c Carrier Only Mode
D/d DMR Deviation Mode
M/m DMR Simplex 1031 Hz Test Pattern (CC1 ID1 TG9)
K/k BER Test Mode (FEC) for D-Star
b BER Test Mode (FEC) for DMR Simplex (CC1)
B BER Test Mode (1031 Hz Test Pattern) for DMR Simplex (CC1 ID1 TG9)
J BER Test Mode (FEC) for YSF
j BER Test Mode (FEC) for P25
n BER Test Mode (FEC) for NXDN
g POCSAG 600Hz Test Pattern
S/s RSSI Mode
I/i Interrupt Counter Mode
V/v Display version of MMDVMCal
<space> Toggle transmit
原文地址:https://www.cnblogs.com/bg7iyn/p/12430353.html