配置SVTI

路由器SVTI站点到站点VPN
         在IOS 12.4之前建立安全的站点间隧道只能采用GRE over IPSec,从IOS 12.4之后设计了一种全新的隧道技术,即VIT(Virtual Tunnel Interface),这种技术是直接采用IPSec来创建的一个VTI隧道接口。相比GRE over IPSec,VTI技术减少了每个包GRE头部的那4B。
        VTI分类:SVTI(静态VTI)和DVTI(Dynamic VTI)动态VTI


默认基本配置完成
R1的配置
crypto isakmp policy 10
 authentication pre-share
crypto isakmp key cisco address 23.1.1.3
!
crypto ipsec transform-set trans esp-des esp-md5-hmac
!
crypto ipsec profile SVTI//名字是SVTI
 set transform-set trans
!
interface Loopback0
 ip address 1.1.1.1 255.255.255.0
 !
interface Tunnel13
 ip address 13.1.1.1 255.255.255.0
 tunnel source 12.1.1.1
 tunnel mode ipsec ipv4
 tunnel destination 23.1.1.3
 tunnel protection ipsec profile SVTI
 !
interface FastEthernet1/0
 ip address 12.1.1.1 255.255.255.0
 duplex auto
 speed auto
 !        
router ospf 1
 router-id 1.1.1.1
 log-adjacency-changes
 network 1.1.1.0 0.0.0.255 area 0
 network 13.1.1.0 0.0.0.255 area 0
!
ip route 0.0.0.0 0.0.0.0 12.1.1.2
R2的配置:
interface FastEthernet1/0
 ip address 12.1.1.2 255.255.255.0
 duplex auto
 speed auto
 !
!
interface FastEthernet1/1
 ip address 23.1.1.2 255.255.255.0
 duplex auto
 speed auto
R3的配置:

crypto isakmp policy 10
 authentication pre-share
crypto isakmp key cisco address 12.1.1.1
!
crypto ipsec transform-set trans esp-des esp-md5-hmac
!
crypto ipsec profile SVTI
 set transform-set trans
!
interface Loopback0
 ip address 3.3.3.3 255.255.255.0
 !
interface Tunnel13
 ip address 13.1.1.3 255.255.255.0
 tunnel source 23.1.1.3
 tunnel mode ipsec ipv4
 tunnel destination 12.1.1.1
 tunnel protection ipsec profile SVTI
 !
interface FastEthernet1/0
 ip address 23.1.1.3 255.255.255.0
 duplex auto
 speed auto
 !
router ospf 1
 router-id 3.3.3.3
 log-adjacency-changes
 network 3.3.3.0 0.0.0.255 area 0
 network 13.1.1.0 0.0.0.255 area 0
!
ip route 0.0.0.0 0.0.0.0 23.1.1.2
R1#show crypto engine connections active
Crypto Engine Connections

   ID  Type    Algorithm           Encrypt  Decrypt LastSeqN IP-Address
    1  IPsec   DES+MD5                   0      196      224 12.1.1.1
    2  IPsec   DES+MD5                 232        0        0 12.1.1.1
 1001  IKE     SHA+DES                   0        0        0 12.1.1.1
R1#show crypto  ipsec sa

interface: Tunnel13
    Crypto map tag: Tunnel13-head-0, local addr 12.1.1.1

   protected vrf: (none)
   local  ident (addr/mask/prot/port): (0.0.0.0/0.0.0.0/0/0)//可以看见这里的感兴趣流为任意源到任意目的,但是注意的是不是所有加入site1的都加密,而是进入SVTI的流量才会加密
   remote ident (addr/mask/prot/port): (0.0.0.0/0.0.0.0/0/0)
   current_peer 23.1.1.3 port 500                                                              
     PERMIT, flags={origin_is_acl,}
    #pkts encaps: 240, #pkts encrypt: 240, #pkts digest: 240
    #pkts decaps: 201, #pkts decrypt: 201, #pkts verify: 201
    #pkts compressed: 0, #pkts decompressed: 0
    #pkts not compressed: 0, #pkts compr. failed: 0
    #pkts not decompressed: 0, #pkts decompress failed: 0
    #send errors 0, #recv errors 30

     local crypto endpt.: 12.1.1.1, remote crypto endpt.: 23.1.1.3
     path mtu 1500, ip mtu 1500, ip mtu idb FastEthernet1/0
     current outbound spi: 0x8965E6D8(2305156824)
     PFS (Y/N): N, DH group: none

     inbound esp sas:
      spi: 0xE60BC2FF(3859530495)
        transform: esp-des esp-md5-hmac ,
        in use settings ={Tunnel, }
        conn id: 1, flow_id: SW:1, sibling_flags 80000046, crypto map: Tunnel13-head-0
        sa timing: remaining key lifetime (k/sec): (4595852/1924)
        IV size: 8 bytes
        replay detection support: Y
        Status: ACTIVE

     inbound ah sas:

     inbound pcp sas:

     outbound esp sas:
      spi: 0x8965E6D8(2305156824)
        transform: esp-des esp-md5-hmac ,
        in use settings ={Tunnel, }
        conn id: 2, flow_id: SW:2, sibling_flags 80000046, crypto map: Tunnel13-head-0
        sa timing: remaining key lifetime (k/sec): (4595851/1924)
        IV size: 8 bytes
        replay detection support: Y
        Status: ACTIVE
          
     outbound ah sas:

     outbound pcp sas:

好好学习,天天向上!
原文地址:https://www.cnblogs.com/MomentsLee/p/10112659.html